CUB CADET LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019Printed In USAOperatOr’s ManualSafe Operation Practices • Set-Up • Operation • Maintenance •
10 Section 2— ASSembly & Set-Up2. Remove the two shoulder bolts and lock nuts in the seat Figure 3-3 Rotate the seat
11Section 2 — ASSembly & Set-UpConnecting the Battery CablesCALIFORNIA PROPOSITION 65 WARNING! Battery posts, terminals, and related accessories c
Controls & Features412IgnitionSwitchModuleHour Meter/Indicator PanelPTO SwitchIndex PlateDeck Lift PedalDrive PedalReverse PedalThrottle ControlFu
13Section 4 — controlS & FeatureSPTO (Power Take-Off ) Switch
14 Section 4— controlS & FeatureSChoke ControlThe choke knob controls the position of the engine choke and is located on the RH console. Pull the
Operation515General Safety manual. Learn to operate this machine SAFELY. Do not risk
16 Section 5— operationStarting the EngineWARNING! This tractor is equipped with a safety interlock system designed for the protection of the operator
17Section 5 — operationDriving The TractorWARNING! Avoid sudden starts, excessive speed and sudden stops. Release the parking brake. Move the thr
18 Section 5— operationDriving On Slopeswhere you may operate the tractor safely.WARNING!
Maintenance & Adjustments6Maintenance ScheduleBefore Each useEvery 10 HoursEvery 25 HoursPrior to StoringClean Battery TerminalsP PLube Front Cast
To The Owner12Safe Operation Practices ... 3Assembly & Set-Up ...
Section 6— Maintenance & adjuStMentS4. If your engine has the oil drain hose setup in Fig. 6-2, see Oil FillerOi
Section 6 — Maintenance & adjuStMentSRemoving The Tractor From Storage Check the engine oil.2. Fully charge the battery and inflate the tires
Section 6— Maintenance & adjuStMentSCleaning the TractorAny fuel or oil spilled on the machine should be wiped off
Section 6 — Maintenance & adjuStMentS deck hanger link. See Fig. 6-7. AdjustmentGearH
Section 6— Maintenance & adjuStMentSAdjusting the Belt TensionTo tighten or loosen the tension on the belt, tighten or loosen the jam nuts on the
Se rvi ce7WARNING! Before performing any service, place parking brake lever, turn the ignition key to
Section 7— ServiceDeck RemovalRemove the mower deck from the tractor as follows: the e
Section 7 — Service5. After all four cotter pins are secure, slide the deck forward and hook the deck to the U-rod.6.
Section 7— Service6. Route the belt as shown in Fig. 7-9. After routing the belt ⁄bracket
Section 7 — ServiceReplacing the BeltZ-Force 48 Remove the deck from beneath the tractor, (refer to Deck Removal on page 24).2. Remove the hex was
Important Safe Operation Practices23General Operation Read, understand, and follow all instructions on the machine and in the manual(s) before atte
Section 7— ServiceChanging the Spindle Assembly Remove the deck from beneath the tractor, (refer to Deck Removal on page 25).2. Remove the hex was
Troubleshooting831Problem Cause RemedyExcessive vibration Cutting blade loose or unbalanced. 2. Damaged or bent cutting blade. Tighten blade
Replacement Parts932Component Part Number and Description KM-49
33Section 9 — Replacement paRtSComponent Part Number and Description
Attachments & Accessories1034Part No. Part
No tes1135
36 Section 11— noteS
37Section 11 — noteS
FEDERAL and/or CALIFORNIA EMISSION CONTROL WARRANTY STATEMENTYOUR WARRANTY RIGHTS AND OBLIGATIONSMTD Consumer Group Inc, the United States Environment
GDOC-100223 Rev. AWARRANTED PARTS:The repair or replacement of any warranted part otherwise eligible for warranty coverage may be excluded from such w
4 Section 2 — important Safe operation practiceS A missing or damaged discharge cover can cause blade contact or thrown object injuries. Stop
CUB CADET LLCMANUFACTURER’S LIMITED WARRANTY FOR Z-FORCE S/Z-FORCE ZERO-TURN RIDING MOWERCub Cadet LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019, Ph
5Section 2 — important Safe operation practiceSChildren Tragic accidents can occur if the operator is not alert to the presence of children. Childr
6 Section 2 — important Safe operation practiceS Periodically check to make sure the blades come to complete stop within approximately (5) five sec
7Section 2 — important Safe operation practiceSWARNING! Your Responsibility — Restrict the use of this power machine to persons who read, understand a
8 Section 2 — Safe operation practiceS(OK) (TOO STEEP)USE THIS SLOPE GAUGE TO DETERMINEIF A SLOPE IS TOO STEEP FOR SAFE OPERATION!To check the slope,
Assembly & Set-Up39Contents of Crate
Comments to this Manuals