Cub Cadet 641 Operator's Manual download pdf (Page 10)

Figure 11

WARNING: Do not exceed the vehicle’s

Total Load Capacity of 1,400 lb., which

includes driver, accessories, and cargo. Do

not exceed 1000 lbs. in the cargo box.

Tailgate

The tailgate can be hinged at the top or the bottom

depending on how you release the holding pins. If you

pull out on the two top pins, the tailgate will swing down.

If you pull out the two bottom pins, you can pivot the

tailgate upwards.

SECTION 3: OPERATING YOUR UTILITY VEHICLE

WARNING: This is an off-road utility vehicle

and it should not be operated on public

highways. Know and comply with all laws and

regulations governing the use of off-highway

vehicles in your area.

IMPORTANT:

Before starting the engine read this

manual and the Engine manual thoroughly to

understand all instructions.

WARNING: Do not run an engine in an

enclosed area. Move the vehicle to an

outside area before running the engine.

IMPORTANT:

Tires are shipped over-inflated. Reduce

inflation pressure in all tires to approximately 5 -6 psi.

Check Neutral Safety Switch

• Sit in the operator’s seat and place key switch in

STOP position.

• Lock parking brake and move gearshift lever to the

forward position.

• Move key switch to START position. The engine

should NOT crank.

• Turn key switch to STOP and move gearshift lever

to the reverse position.

• Move key switch to START position. The engine

should NOT crank.

• Turn key switch to STOP.

• Keep engine compartment clean and be sure fan or

flywheel screens remains installed and clean.

Starting Engine

• Sit in the operator’s seat and place key switch in

STOP position.

• Move gearshift to the N (Neutral) position and lock

parking brake.

• Pull out the choke knob if engine is cold.

• Turn key to the START position.

• Release key to the RUN position when engine

starts.

• If engine does not start, wait a few seconds and

repeat procedures.

• After engine starts, push in choke knob.

IMPORTANT:

DO NOT run the starter continuously for

more than 5 seconds, otherwise the battery may

discharge quickly.

NOTE: If engine surges after starting while idling or

driving at a low speed, apply choke as needed until

engine has warmed up.

IMPORTANT:

Do not operate the engine under full load

until engine has warmed up.

Stopping Engine

• To stop utility vehicle, release accelerator pedal

and depress brake pedal until vehicle comes to a

complete stop.

• Move gearshift lever to N (Neutral) position.

• Lock parking brake and turn key switch to STOP

position.

• Remove the key when not in use.

Driving Utility Vehicle

• Make sure front wheels are turned to the desired

direction.

• Depress brake pedal to release parking brake.

• To avoid damaging transmission, depress brake

pedal fully and make sure vehicle is completely

stopped before shifting into Forward or Reverse.

Cargo Box

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Comments to this Manuals

No comments

Cub Cadet 641 Operator's Manual Page 10

Comments to this Manuals

Related products and manuals for Tractor Cub Cadet 641