Cub-cadet GT-2186-48 User Manual download pdf (Page 18)

SECTION III. ADJUSTMENTS

This section contains adjustment information for the

Model GT 2186 tractor. Adjustment information for the

44-inch deck is located in Section V – Mower Deck

beginning on page 33.

ADJUSTING THE SEAT

WARNING

Do not adjust the seat when the tractor is

moving. Adjusting the seat while the tractor is

moving could cause the operator to lose control

of the tractor.

Before starting the tractor, adjust the seat forward or

rearward to the most comfortable driving position. To

reposition the seat, move the seat adjustment lever

(see Figure 10) upward and slide the seat forward or

rearward. Release the adjustment lever when the seat

is comfortably positioned. Gently rock the seat forward

or rearward to be sure the seat is locked in place.

Figure 10

ADJUSTING THE BRAKES

During normal operation of this tractor, the brakes are

subject to wear and will need periodic examination and

adjustment.

To check the brake adjustment, position the tractor on

a firm and level surface. Stop the tractor engine and

remove the ignition key. Pull and lock the transmission

release lever in the “TRANSMISSION RELEASED”

position. Perform the following checks:

1. Engage the brake pedal lock. If the tractor can be

pushed forward or rearward, the braking force

must be increased.

2. Release the brake pedal lock. If the tractor cannot

be pushed forward or rearward, the braking force

must be decreased.

To adjust the braking force, refer to Figure 11 and

proceed as follows:

1. Place the tractor on a level surface with the brake

pedal lock disengaged. Stop the tractor engine

and remove the ignition key.

2. While working from the underside of the tractor,

facing the threaded end of the rod:

• Remove the internal cotter pin from the brake

rod adjustment ferrule and disconnect the fer-

rule from the brake cam.

• Loosen the hex jam nut from against the ferrule.

To increase the braking force—

Turn the ferrule clockwise (inward) one full turn at

a time until the ferrule can be inserted into the

brake cam while applying a minimal tension on

the spring.

To decrease the braking force—

Turn the ferrule counterclockwise (outward) one

full turn at a time until the ferrule can be inserted

into the brake cam while applying a minimal

tension on the spring.

3. Turn the ferrule counterclockwise (outward) one

full turn to release the slight spring tension.

Tighten the jam nut against the ferrule, then insert

the ferrule into the brake cam and secure with the

intenal cotter pin.

Figure 11. Viewed from top (fender off).

Recheck the brake adjustment to ensure proper brake

operation before operating the tractor. If brake rod

adjustment does not correct the problem, see your

authorized Cub Cadet dealer.

SPRING

BRAKE ROD

INTERNAL

COTTER PIN

ADJUSTMENT

FERRULE

BRAKE

CAM

HEX JAM NUT

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 59 60

Comments to this Manuals

No comments

Cub-cadet GT-2186-48 User Manual Page 18

Comments to this Manuals

Related products and manuals for Special machinery Cub-cadet GT-2186-48