Update Manual2005-2 200 Series Snow Thrower UpdateMTD Products Inc - Product Training and Education DepartmentFORM NUMBER - 769-0208710/2005NOTE: Thes
200 Series Single Stage Snow Throwers66.2. Remove the three screws securing the front of the shroud to the auger housing using a 3/8” wrench.6.3. Remo
200 Series Single Stage Snow Throwers78. FOUR-CYCLE MODELS8.1. Some of the MTD single-stage snow throwers are powered by four-cycle Tecumseh Snow King
1Introduction ... 1Drive Belt
2
200 Series Single Stage Snow Throwers11. INTRODUCTION1.1. For the 2005-2 manufacturing year several changes have been made to the single stage snow th
200 Series Single Stage Snow Throwers22.3. In the disengaged position it is possible to roll the belt off the bottom of the auger pulley. See Figure 2
200 Series Single Stage Snow Throwers33.4. Remove the bearing housing and bearing from the auger shaft. See Figure 3.4. NOTE: The left side (Drive Sid
200 Series Single Stage Snow Throwers45. CABLE REMOVAL5.1. Remove the belt cover as described in the belt removal section of this manual to expose the
200 Series Single Stage Snow Throwers55.6. Pinch the tabs on the cable housing with a pair of needle nose pliers to free it from the holder on the fra
Comments to this Manuals