Cub Cadet CC 550 SP User Manual download pdf (Page 11)

11Section 3 — ASSembly & Set-Up

Adjustments

Cutting Height

1. The cutting height adjustment lever is located above the

rear left wheel. See Fig. 3-8.

a. Pull the lever out and away from the mower.

b. Move the lever forward or back for desired cutting

height.

c. Release lever towards mower deck.

Set-Up

Gas and Oil Fill-Up

Refer to the Engine Operation section in the Engine manual for

additional engine information.

1. Add oil provided before starting unit for the first time out

of the box.

2. Service the engine with gasoline as instructed in the

Engine Operation section of the Engine manual.

WARNING: Use extreme care when handling

gasoline. Gasoline is extremely flammable and the

vapors are explosive. Never fuel the machine

indoors or while the engine is hot or running.

Extinguish cigarettes, cigars, pipes and other

sources of ignition.

3. Charge battery as instructed in the Service section of this

manual (Electric Start Units).

Side Discharge Chute

To convert to side discharge, make sure grass catcher is off of the

unit, the rear mulch plug is removed, and rear discharge door is

closed.

1. On the side of the mower, lift the mulching plug.

2. Slide chute hooks under hinge pin on mulching plug

assembly. Lower mulching plug. See Fig. 3-7. Do not

remove side mulching plug at any time, even when you are

not mulching.

Figure 3-7

Figure 3-8

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

No comments

Cub Cadet CC 550 SP User Manual Page 11